Beijing stamping processing plant, what are the design details of the continuous die + 3.0 stamping parts design system

The stamping staff in charge of the Beijing stamping processing plant said that with the rising wages of workers in the stamping industry, reducing the labor cost of stamping has become a top priority for hardware manufacturers. And one of them is the use of continuous molds. The use of continuous molds can establish a low-cost and high-efficiency automated stamping production line. However, the continuous mold requires precision and complex parts. The issues that need to be paid attention to in the design are more sophisticated than the general stamping die. This is mainly manifested in the following aspects. Xiaoshuo has compiled some information for you, and I will share it with you below: 　　(1) When there are more punching holes, The length of the small punch should not be too large. For multi-punch stamping dies, punches of different heights can be made according to the size of the punch to form a stepped type, which can avoid the large value of punching force of each punch from being generated at the same time, which is useful Reduce the punching force of the mold and reduce the load of the punch. But it should be noted that for step punches, in order to ensure that the punches have sufficient rigidity, the smaller punches should be made shorter, and the larger ones should be longer. The difference between the two is the thickness of the sheet. In this way, the large holes are punched first and then the small holes are punched. Otherwise, the material will squeeze a small punch when punching a large hole, and the small punch will be broken due to insufficient rigidity.　　(2) Continuous die try to add stopper, side edge and other step positioning devices. 　　 When using continuous die to stamp the workpiece, it is necessary to solve the problem of accurate positioning of the strip and ensure that the step distance of the continuous die is consistent. Only then can it be possible to punch out qualified parts. In continuous molds, the commonly used positioning devices have several forms such as fixed stop pins, guide pins, guide plates, and side blades. When stamping, first use the fixed stop pin for preliminary positioning, and use the guide pin installed in the mold to ensure the correct positioning of the strip when blanking. The side edge is used to control the feeding distance of each step. The length of the side edge should be equal to the step length plus 0.05-0.5mm, depending on the thickness of the material. Hardware, 15 years of focus on Beijing stamping processing plant, 20,000+ sets of customized stamping die production experience, monthly processing capacity of 100+ sets of molds, hundreds of precision processing production equipment, daily production capacity of 3 million punches, and silk-like stamping accuracy up to 0.01 mm, the raw materials are imported and the original national standard factory, and 16 quality inspections are strictly controlled. It can quickly solve time-critical problems for you, solve stamping accuracy problems, and solve production quality problems. Choose, choose rest assured!